![]() ![]() I change the Export Scale in A1 Zbrush file to 100 and Export. Zbrush has rescaled to suit its tools internally and this is the correction so that after editing, the object exports at the correct scale. This is the internal calculation which follows on from the default Export Scale = 0. Other bird form Zbrush files have Export scale set to 5dp numbers. A1 is currently set to 1 B1 is currently set to a 5dp number. Had to multiply by 100 I don’t remember this issue occuring with the half-scale prints. ![]() ![]() Print Volumes:įorm 3L: F2, F1, D1, D2, D3, B1, B2, B3, A1, A2, A3, A4, C4 B2 in Form 3L – test to see which birds fit – not properly set up for printĬomplete: Wire F, Wire D, Wire B, Wire A, Wire C Import into Zbrush: Boolean to create hole. Make Texture.ĭecimate: Keep UVs, 10% For the SLA Print model:Įxport Dynamesh without texture at lowest subdiv. UV using polygroups using 2MB texture map size. If Dynamesh is OK, just alter the hole template (x. This means I need to look again at the Zbrush files and export 3 files per form as follows: For the Volume Calculation model: Meanwhile, when investigating the forms’ volumes in Netfabb, I realised that I need to prepare meshes especially for that purpose: solid, with a hole throught the middle, like the originals.Īnd the digital models would benefit from further optimisation for display speed, now that I have a better understanding of Sketchfab’s requirements. So I’ll be able to do full size prints of Flutter Of Birds forms, but the meshes will need re-editing before printing, because they were hollowed out and set up to print half-size. The Form 3L has finally arrived in PrintCity – the large volume SLA (resin) printer. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |